Specification :
1. coil cart for uncoiler
2. single side/ double side uncoiler, support arm stand for single side uncoiler
3. leveling/ leveling+shearing stand
4. loop bridge
5. side guide stand
6. single slitting knife stand/ double slitting knife stand
7. loop bridge and scrap winder
8. tension pad stand
9. recoiler
10.coil cart for recoiler
11.electric control system

Features for Automatic Slitter Line :
1.By means of Programmable Logic Controller (PLC), system performance is based upon the characteristics of various
   Metal sheets, and switches Hihg / Low speed operating mode quaomatically, so as to achieve improved efficiency
   and reduced maintenance dramatically.
2.For lower malfunctioning, the material uncoiler uses an expand / shink hydraulic cylinder that is mounted on an
   integrated steel frame.
3.The materialuncoiler is equipped with a high efficiency disctype brake, its tension is adjusted by the air-pressure loop.
   Under this circumstance, the time for tension adjustment is reduced, also, the forced monetary braking is occurred
   thus free from loosen of coil.
4.The pre-loader is equipped with DC various-speed motor drive, so that a synchronized speed copperate to the
   production line could be governed.
5.Slitting Knives are mounted on an integrated frame with a sepreated transmission, that means enhanced rigidity
   structure of machine, lower vibration amplitude of Knives, and excellent yields could be produced.
6.The datum plane and accuracy of Slitting Knives' axes are all to be fabricated within 0.006mm. in tolence, so that
   makes higher duration of Slitting Knives and much excellent accury of outputs of the Slitting Line.
7.For securing the stability of Slitting Line during operation, the tension controlled roll-up device with slip-differential
    structure is designed for the waster.
8.The straight type tightener uses high elastics and resistive carpet as surface materials, so keep the outputs of the Line
   smoother. In addition, it also equipped a pressure-balance device to keep an even-pressure overthe both side of
   materials that touched with the tinghtener.
9.The Recoiler is equipped with an improved / high rigid holder, that causes reduced of lead time. An air-pressure
   adjustable back-pressure device is equipped on the separator mechanism, so that a constant hold-pressure could
   be reached for recoil.
10.Self-tension design enable to retain a better tightness during recoil.